Porosity is a common defect in die castings. Gas porosity and shrinkage porosity are mainly two types of porosity in casting. Squeeze casting is a
Squeeze casting has many advantages over high-pressure die casting(HPDC). Here we are discussing indirect aluminum squeeze casting, a process much closer to aluminum high-pressure die
The aluminum die casting process is the most popular way to make castings because it works well to produce a large number of castings. Unfortunately, parameters and non-standard operations can cause many kinds of defects.Here, we will discuss the different aluminum die casting defects causes and solutions.Internal and superficial are the two categories of aluminum die casting defects.
For aluminum alloy die casting parts, there are lots of surface treatment methods, below are some common methods: 1. Powder Spraying (Powder Coating) Powder
Common used die-casting aluminum alloys are mainly divided into three categories: Al-Si Alloy: YL102/ A413/305/ADC1/ALSI12 Al-Si-Cu Alloy: YL112/A380/306/ADC10/ALSI8CU3, YL113/A383/383/ADC12 Al-Si-Mg Alloy: YL101/A360/309/ADC3/ALSI10MG For aluminum-silicon alloys
There are many process methods for making metal materials into desired products, such as casting, forging, extrusion, rolling, drawing, stamping, cutting, powder metallurgy, and so
Blister products are processed with plastic. The production principle of the product is to heat and soften the flat plastic hard sheet material, then adsorb
Si Element The Si content of cast aluminum is mainly concentrated at 5%-11%, and the elongation of hypereutectic aluminum alloys exceeding 11% is greatly reduced,
High-pressure die casting is also known as HPDC or traditional die casting. This is a unique metal casting process where molten metals like zinc, Steel,
